This coil packing machine refers to steel coil master

Every one of the pieces which have been explained, with each other comprise a whole machine block which might be readily mounted on or detached through the structure of the main coil packing machine, a section 312 in which is proven in FIG. 9, through hefty mounting bolts 313 which lengthen through near appropriate openings 314 in the body in the machine with all the bolt mind ideally sitting within a counter-sunk golf hole 316. The body 280 has accuracy tapped pockets 317 to obtain the mounting bolts 313. Even though the machine disables as described and shown within these FIGS. 9, 11 and l0 and in one other figures currently defined, are relatively hefty, the inner surface area is machined in order that it may be attached in specifically fixed experience of theouter surface of the coil packing machine physique, and only two of the heavy bolts previously mentioned defined are necessary to maintain it in precisely the appropriate relation to the other areas of the coil packing machine.

It will be noted that the sprockets such as 291, 310 and 286, with their mountings all project beyond the inner surface of the frame, but they are not close to the side’of the frame 230 and extend into the opening in the body of the machine and can thus readily be driven by motors located inside the machine body.

Talking about FIG. 12, there exists here highlighted a signing up handle device which can certainly be defined:

Device in coil packing machine symbolizes an online which can have insignia imprinted thereon, a great simply being mentioned at 201. If the insignia, of which it will be understood there is a very large number, uniformly spaced along the web, pass a predetermined spot 202 at the proper interval, the electric eye will not actuate the relay circuit, but if the insignia become slightly out of register, the electric eye mechanism 203 will immediately actuate the relay which will act in the usual manner through the control circuits and will cause one or the other of the switches 205 and 204 to be energized and electric current to be conducted either to solenoid 206 or to solenoid 207, as the case may be. If solenoid 206 is actuated, dog 210 locks dog ring 211, if solenoid 207 is actuated, a dog 208 is pushed into the notches of the dog ring 209 and locks it against turning, or.

You may also like...